Three Important Precautions for Installing a Submersible Bore Pump

Submersible pumps are ideal for installation in boreholes. These devices are designed for efficient water extraction and have numerous benefits over alternatives like centrifugal pumps. As implied, this pump is designed for complete submersion in water. It is favoured because it does not require priming for operation. The efficiency of the pump is also quite high. It does not demand a lot of power for pumping. However, you should note that the performance will be influenced and even compromised by the installation. Here are precautions to keep in mind for effective installation of a submersible pump. 

Choose an Ideal Pump

The installation of your bore pump will not matter if the chosen device is not suitable for your needs. In simple terms, it is essential to acquire a bore pump that is well-matched to your reservoir and needs. When choosing your product, consider the size of your borehole. You should ensure that the pump size can fit into the bore during the installation.

Also, consider the pumping height of the unit and ensure that it can draw and lift water over the required distance. The delivery size and the discharge rate of the pump are critical factors. In addition, evaluate the cooling design of your preferred pump to prevent premature wear, general deterioration and gradual failure due to overheating.

Inspect the Pump Parts

It is important to check the condition of the pump before installing it. In general, the submersible pumps designed by a reliable manufacturer are delivered in exceptional form. However, there are unforeseen problems which can occur due to damage during transportation or handling. Therefore, it is always advisable to conduct an assessment.

Ideally, you should confirm whether the specifications of the pump are as expected. The critical components that you should check include the motor rating, phase configuration and the cables. Then, you should look at the individual components and ensure that they are in a good state. It is not advisable to install dented, torn or otherwise faulty parts.

Check the Fittings

When installing your submersible pump, you should check the integrity of the fittings and ensure that the components are tightened adequately. Often, pumps, like other machines, fail because of poor placement of critical fittings. If they are properly installed, they should be tight. Otherwise, there will be a gradual loosening of components and subsequent failure of the entire system.

The installation of submersible bore pumps can be challenging. Therefore, where possible, opt for professional help from your supplier or a specialist contractor. 

Share